60 Series Detroit Valve Adjustment. Series 60 Electronic Unit Injector Terminal Installation Detroit Detroit Series 60 12.7L Valve Adjustment Chart; Series 60 - Section 13.4 Valve Lash for the Series 60G Engine; Series 60 - Section 13.3 Engine Tune-Up Procedures for the Series 60G Engine; Series 60 - Section 13.1 Engine Tune-Up Procedures; Series 60 - Section 13.2 Valve Lash, Injector Height (Timing) and Jake Brake® Lash Adjustments Valve Lash and Injector Height Adjustment Sequence 6
Series 60 Electronic Unit Injector Diagram Detroit Diesel from www.detroitdieselengines.info
Reference the following chart that brings together essential information for servicing the Series 60 diesel engines. Table 12-2a Valve Lash and Injector Height Adjustment Sequence NOTICE: Never set the valves and injector of the same cylinder at the same time
Series 60 Electronic Unit Injector Diagram Detroit Diesel
Detroit Series 60 12.7L Valve Adjustment Chart; Series 60 - Section 13.4 Valve Lash for the Series 60G Engine; Series 60 - Section 13.3 Engine Tune-Up Procedures for the Series 60G Engine; Series 60 - Section 13.1 Engine Tune-Up Procedures; Series 60 - Section 13.2 Valve Lash, Injector Height (Timing) and Jake Brake® Lash Adjustments Intake valve clearance and fuel injector height are adjusted using an adjusting set screw and locknut located at the valve or injector end of the rocker arm To adjust the intake valves, insert a 0.203 mm (.008 in.) feeler gage between the tip of the valve stem and the valve button at the end of the rocker arm
How To Do A Full Overhead On A Detroit 60 Series ! Taught by an ASE. The valve lash adjustments section has been revised Accurate adjustment of clearance between valve buttons, intake and exhaust valves is important if maximum performance and economy are to be obtained
Series 60 Electronic Unit Injector Diagram Detroit Diesel. The valve lash on all Series 60 engines must be measured and, if necessary, adjusted at the initial period listed in Table 1 Adjust the valves on the corresponding cylinders listed in Table "Valve Lash and N3 Injector Setting Adjustment Sequence".To adjust the intake valves, insert a 0.203 mm (0.008 in.) feeler gage between the tip of the valve stem and the valve button at the end of the rocker arm.